Find Jobs
Hire Freelancers

ATTINY Thermostat with IR Remote

€250-750 EUR

Imefungwa
Imechapishwa over 5 years ago

€250-750 EUR

Kulipwa wakati wa kufikishwa
We are looking for a SW devoloper for a small attiny project. Hardware will be designed on our side. The project is a small thermostat which is switching a heater element on and off. The UI is two 7-segment Displays and 5 pcs switch buttons. 1 ON/OFF, UP/Down, Set/Enter, Start delay. An IR Remote control is duplicating this interface. Heater is controlled by GPIO on Attiny, for security reasons there is allso a tilt sensor in serial, which is also obsurved by an GPIO. An NTC 10k is used to meassure the temperature. Resolution 1°C, Accurency 2°C Displayed Temperature: 0-40°C Settable Temp: 7-28°C Antifreeze: 7°C SW should be written in C/C++. Documentation in english.
Kitambulisho cha mradi: 17947713

Kuhusu mradi

3 mapendekezo
Mradi wa mbali
Inatumika 5 yrs ago

Unatafuta kupata pesa?

Faida za kutoa zabuni kwenye Freelancer

Weka bajeti yako na muda uliopangwa
Pata malipo kwa kazi yako
Eleza pendekezo lako
Ni bure kujiandikisha na kutoa zabuni kwa kazi
3 wafanyakazi huru wana zabuni kwa wastani €1,333 EUR kwa kazi hii
Picha ya Mtumiaji
Hi, I hope you are doing well. I have extensive experience with AVR Attiny microcontroller developing similar projects. I have also hardware available for quick prototyping and testing. I understand your requirement to thermostat controller with IR control. I have understood your requirements and I can execute this project in less possible time. Please send me message for further discussion. Looking Forward, Khawaja
€1,500 EUR ndani ya siku 10
4.9 (66 hakiki)
6.5
6.5
Picha ya Mtumiaji
Hi there , I am an electrical engineer with 19 years experience in this area. I am interested in your project ATTINY Thermostat with IR Remote, please send me a chat message , I have come questions and I need more details. Rahul Soni
€998 EUR ndani ya siku 3
4.9 (20 hakiki)
6.1
6.1
Picha ya Mtumiaji
Hello, I am an experienced embedded system engineer (8 years+). I have programmed ATTINY and ATMEGA uC in the past. I am also a PhD candidate in Automation and Robotics. I can help you with your project. Thanks
€1,500 EUR ndani ya siku 10
4.9 (13 hakiki)
5.1
5.1

Kuhusu mteja

Bedera ya AUSTRIA
Vienna, Austria
0.0
0
Njia ya malipo imethibitishwa
Mwanachama tangu Okt 11, 2018

Uthibitishaji wa Mteja

Asante! Tumekutumia kiungo cha kudai mkopo wako bila malipo kwa barua pepe.
Hitilafu fulani imetokea wakati wa kutuma barua pepe yako. Tafadhali jaribu tena.
Watumiaji Waliosajiliwa Jumla ya Kazi Zilizochapishwa
Freelancer ® is a registered Trademark of Freelancer Technology Pty Limited (ACN 142 189 759)
Copyright © 2024 Freelancer Technology Pty Limited (ACN 142 189 759)
Onyesho la kukagua linapakia
Ruhusa imetolewa kwa Uwekaji wa Kijiografia.
Muda wako wa kuingia umeisha na umetoka nje. Tafadhali ingia tena.