Uhandisi Jobs

We are looking for ideas on how to have a small flat plastic container (approx 85mm x 55 mm x 4mm) fold in half to dispense fluid from a dropper nozzle (at the seam) that gets exposed when container is folded in half. The challenge, and specifically what we are looking for ideas on, is how to pass fluid across the seam when folded. Ideally the internal volume would not change until mostly folded to prevent squeezing out fluid or sucking in air during the folding process. Only after it is almost fully folded should there be pressure to squeeze out a drop of fluid. I have attached various rough ideas for this. Ideas like how straw can bend or how a fire bellows works can be used for inspiration. My goal is that this is about the size of a thick credit card. It would be flat, nozzle would be...

I need a professional skilled in Ansys for a basic-level project. The primary focus will be on simulating liquid fluid flow. We need a geometry similar to a tee mixer as depicted in the provided figure. The horizontal pipe has a diameter of 100 mm, while the vertical pipes have a diameter of 40 mm each. We're dealing with a fluid with properties akin to water. The conditions for the horizontal pipe include a flow rate of 4 l/s and a temperature of 20°C, while for the vertical pipes, the flow rate is 1 l/s and the temperature is 60°C. Tasks to be carried out: 1- Verification of Mass and Energy Balances: This involves assessing velocity, temperature, and pressure profiles within the system. Additionally, improving mesh quality using a curvature-based criterion and commenting...