Convert numerals from pixel into dxf format

Bodi ya Ufafanuzi ya Umma

• 

  iqbalkhatri55

  • Miaka 3 iliyopita

  Please check entry No. 9

  • Miaka 3 iliyopita
• 
  Mwenye Shindano

  • Miaka 3 iliyopita

  If possible, the width here should also be 1mm at least. It would be great if you could change the shape of the "5" that the two gaps become a minimal width of 1mm.

  • Miaka 3 iliyopita
• 
  Mwenye Shindano

  • Miaka 3 iliyopita

  Please make this gap 1mm wide.

  • Miaka 3 iliyopita
• 
  Mwenye Shindano

  • Miaka 3 iliyopita

  Okay, I checked it. Its almost perfect. The minumum should be 0.3mm EVERYWHERE and please also enlarge the gap in the "5" to 1mm.

  • Miaka 3 iliyopita
• 

  iqbalkhatri55

  • Miaka 3 iliyopita

  Yes, The Radius is 0.3 MM on all sharp corners.

  • Miaka 3 iliyopita
• 
  Mwenye Shindano

  • Miaka 3 iliyopita

  check the radius also here - and everywhere.

  • Miaka 3 iliyopita
• 
  Mwenye Shindano

  • Miaka 3 iliyopita

  Did you ckeck the minumal radius here?

  • Miaka 3 iliyopita
• 

  iqbalkhatri55

  • Miaka 3 iliyopita

  Please check the upload file.

  • Miaka 3 iliyopita
• 

  iqbalkhatri55

  • Miaka 3 iliyopita

  https://workupload.com/file/ffyH4tq966q

  • Miaka 3 iliyopita
• 
  Mwenye Shindano

  • Miaka 3 iliyopita

  That looks quite good. Please upload it to workupload.com and share the link here, then, I'll chech it. Thank you.

  • Miaka 3 iliyopita

Onyesha maoni zaidi