Plastic Astronaut helmet with visor with 3D printable file in STL format

  • Hali: Closed
  • Zawadi: $150
  • Wasilisho Zilizopokelewa: 23
  • Mshindi: makhan22

Maelezo ya Shindano

I'm needing to design a plastic Astronaut helmet with a spring loaded mirrored lens visor. It will need a small contained square over the mouth for a voice box to be inserted. The measurements on the voice box to come later.

The visor will cover the entire face, and held down by a latch, and pop open/up with springs so the face fully shows when latch is undone. Attached is a good starting point.

Ujuzi unaopendekezwa

Winner
Shindano Lililohusishwa
Tuma Shindano kama Hili

Maoni ya Muajiri

“Amazing work, creative, and enjoyable to work with. Highly recommend!”

Picha ya Profaili adschiel, United States.

Wasilisho kuu kwenye hili shindano

Angalia wasilisho zaidi

Bodi ya Ufafanuzi ya Umma

  • adschiel
    Mwenye Shindano
    • Miaka 5 iliyopita

    Hello all, and thank you all for your entries. A winner has been decided and has been notified. Thank you again.

    • Miaka 5 iliyopita
  • amirfreelancer12
    amirfreelancer12
    • Miaka 5 iliyopita

    HI , working on it , almost finish , please wait

    • Miaka 5 iliyopita
  • ahmadnazree
    ahmadnazree
    • Miaka 5 iliyopita

    Hi CH, please rate #22 . Thank you very much.

    • Miaka 5 iliyopita
  • prashant8080
    prashant8080
    • Miaka 5 iliyopita

    If I provide you the update, is there any chances you will respond ? or can guide with a corrections ?
    ( As I have prepared the Entire Model by using your picture as a reference, I feel that there is something still remaining, and that is what I am expecting from you if you can send me the feedback for the same ? )

    • Miaka 5 iliyopita
    1. adschiel
      Mwenye Shindano
      • Miaka 5 iliyopita

      Yes, I will give feedback for every entry. Thank you for your interest.

      • Miaka 5 iliyopita
  • adschiel
    Mwenye Shindano
    • Miaka 5 iliyopita

    Thanks for the interest. Size will be for an average size adult head... Not overly snug like a baseball helmet, but loose easy to get on and off... I would like to receive JPG photos displaying the helmet from all sides, and a 3D printable file in STL format.

    • Miaka 5 iliyopita
  • Vadymykh
    Vadymykh
    • Miaka 5 iliyopita

    Any information about 1) size 2) dimensions 3) end result? What do you expect to receive? .STL, .STP, .JPG?

    • Miaka 5 iliyopita

Onyesha maoni zaidi

Jinsi ya kuanza kwa kutumia mashindano

  • Chapisha Shindano Lako

    Chapisha Shindano Lako Haraka na rahisi

  • Pokea wasilisho nyingi

    Pokea Wasilisho Nyingi Kutoka kote ulimwenguni

  • Tuza wasilisho bora zaidi

    Tuza wasilisho bora zaidi Pakua faili - Rahisi!

Tuma Shindano Sasa ama Jiunge nasi Leo!